Page 1 of 1
Slave cylinder boot
Posted: Tue Jun 24, 2025 9:10 pm
by Classiccars
Hi gang are you able to advise where to buy or a part number for this boot.At the front it is 3cm across and the part that pushes on the piston is 4cm wide.Bought two recently one too small one too big.
- 20250624_160332.jpg (689.76 KiB) Viewed 121 times
Re: Slave cylinder boot
Posted: Tue Jun 24, 2025 9:39 pm
by les
You’d expect to stretch the boot somewhat to fit, have you tried that ?
Re: Slave cylinder boot
Posted: Tue Jun 24, 2025 11:52 pm
by oliver90owner
It’s part number is written on it! Lockheed 33427
Try your local brake and clutch repairer?
Re: Slave cylinder boot
Posted: Wed Jun 25, 2025 9:17 am
by svenedin
Try Powertrack Ltd. They are the largest UK stockist of British classic car brake parts.
https://www.powertrackbrakes.co.uk
Stephen
Re: Slave cylinder boot
Posted: Wed Jun 25, 2025 9:20 am
by les
The part number on the boot illustrated is not, I think, the one he wants !
Re: Slave cylinder boot
Posted: Wed Jun 25, 2025 10:21 am
by Sleeper
edited...
Re: Slave cylinder boot
Posted: Wed Jun 25, 2025 10:23 am
by Sleeper
Re: Slave cylinder boot
Posted: Wed Jun 25, 2025 1:59 pm
by oliver90owner
les wrote: ↑Wed Jun 25, 2025 9:20 am
The part number on the boot illustrated is not, I think, the one he wants !
I think it is. He likely has the Lockheed 38253, which seems a common one - but presumably 38mm - and he wants a 33mm size?
Maybe if he posted where that slave cylinder came from, it might be easier - as there weren’t many hydraulically operated clutches fitted to moggie minors
Re: Slave cylinder boot
Posted: Wed Jun 25, 2025 10:16 pm
by Classiccars
Thank you I have left a message on the website mentioned and yes it is a hydrolic clutch that was fitted previously.I would imagine it is the 38mm I am after as at its widest it is around 40mm.colud be 38mm.
