Page 1 of 1
Slave cylinder
Posted: Sun Jun 15, 2025 4:44 pm
by Classiccars
:Hi all please can you advise the orientation of these parts.I am .unsure if the concave sides go together or am I wrong please.
- 20250615_161630.jpg (688.81 KiB) Viewed 130 times
Re: Slave cylinder
Posted: Sun Jun 15, 2025 5:06 pm
by les
The concave end faces the fluid, the flat sides touch. If I’m understanding your question !
Re: Slave cylinder
Posted: Sun Jun 15, 2025 8:41 pm
by Classiccars
Thank you Les so am I correct to say the flat sides against each other.The opposite to whst I have here.So would thst mean the concave of the piston would then take rod end into its dish.
Re: Slave cylinder
Posted: Sun Jun 15, 2025 9:03 pm
by les
Yes.
Re: Slave cylinder
Posted: Mon Jun 16, 2025 8:00 am
by philthehill
The orientation of the seal in your photo above is correct in that the concave faces into the cylinder.
The operating rod (No: 16 in the link below) sits into the outward facing concave of the metal piston.
See link below for how the assembly (No: 10) goes together:-
https://www.moss-europe.co.uk/en-gb/clu ... 14--03--01
Note:- There are variations to the slave cylinder but they are all have the same style of seal and piston.
Re: Slave cylinder
Posted: Mon Jun 16, 2025 7:05 pm
by Classiccars
Thank you gents a great help as ever.