Page 1 of 1
HIF 44 Assembly Question
Posted: Mon Nov 28, 2022 6:22 pm
by moggiegeek
In photos below an HIF44 which has been refurbished. The question is whether the Throttle spindle lever is in the correct position. It seems to me to be in the wrong position for connecting the throttle cable if using the heat shield.
What do you think?
- IMG_20221128_171202.jpg (994.76 KiB) Viewed 1050 times
- IMG_20221128_171202.jpg (994.76 KiB) Viewed 1050 times
Re: HIF 44 Assembly Question
Posted: Mon Nov 28, 2022 7:47 pm
by paul 300358
Its on the wrong way round!
Re: HIF 44 Assembly Question
Posted: Mon Nov 28, 2022 8:45 pm
by moggiegeek
So should be rotated 180 degrees anticlockwise?
Re: HIF 44 Assembly Question
Posted: Mon Nov 28, 2022 9:15 pm
by Sleeper
90 degrees anti-clockwise
- hif1.jpg (59.85 KiB) Viewed 1025 times
John ;-)
Re: HIF 44 Assembly Question
Posted: Tue Nov 29, 2022 7:00 am
by moggiegeek
Looking at it I think cos of the "oblong" profile of the shaft it will only do 0 degrees and 180. I'll try and see.
Re: HIF 44 Assembly Question
Posted: Tue Nov 29, 2022 7:20 am
by Sleeper
Your shaft seems to be in the same position as mine...
Could be the wrong throttle quadrant ,,,unless they have a " square" cutout?
John ;-)
Re: HIF 44 Assembly Question
Posted: Tue Nov 29, 2022 6:22 pm
by moggiegeek
I was able to knock back the tab washer on the throttle shaft, remove bolt, rotate quadrant 90 degrees and it's a much better fit, aligning with the mini type throttle cable mounting on the heat shield.
Would you run it with the heated manifold connected?
- IMG_20221129_181739.jpg (1.19 MiB) Viewed 965 times