Morris Minor Owners Club

Good Evening,

For anyone who has fitted a full carpet set, including under felt, would a standard can of 500ml spray carpet adhesive be adequate to apply to the underfelt/floor layer and the carpet/under felt layer ?
Any recommendations on a good heavy duty carpet adhesive welcome ?

Thanks Moggers

Do you really want to be "gluing" the carpets / underlay down? Is there a real need to do so.

Personally I would not stick felt underlay down or carpet for that matter.
Underlay is notorious for soaking up the damp especially in the foot-wells
Better if fitted so as to be able to remove if damp in the underlay is found.
Once stuck down not much can be done
I would fit loose under the carpet and let the carpet hold the underlay in place.

The only reason I thought glueing was required is because some sellers of under felt and carpet recommend spray adhesive.
I would like the fit to be taut, no sagginess. Can this be achieved in the medium to long term without glueing down the components ?

You'll need some adhesive for the side edging strips - the bits of carpet that go between the floor and the door 'step'. If you get a decent quality carpet that fits well then there shouldn't be any sagginess.

Agreed - use spray adhesive for the side strips and double sided carpet tape on the main areas if you really want to stick the underlay and carpet down.
My underlay and carpet panels are fitted without adhesive of any kind and are held firmly in place at the front by the seat mountings and at the rear by the back of the seat frames. Never had a problem with the carpets moving.
Also a good idea to use heavy rubber mats in the footwells, available with the correct logo from most suppliers.

Lovely colour and fit there Boomlander Is that a re-spray job or new ?

I'll follow everyone's advice, a bit of adhesive on the sides only. This will allow me to get to the brake master cylinder without destroying the carpet.
Thanks all.

This will allow me to get to the brake master cylinder without destroying the carpet.


(Carpet left unstuck for access to the lubrication point for the steering rack also of course )

[quote="fasthamster"]Lovely colour and fit there Boomlander Is that a re-spray job or new ?

The carpets are hand made (Not by me I must add!) the paintwork is all newly sprayed.

I have a trimmed 'sole replacement' evo-sticked to my carpeted wheel arch as this is where the accelerator foot rests and it always wore through there. Properly trimmed it looks good and saves the carpet or at least a hole in the carpet.

Yes just get a can of contact adhesive, one should be enough. Just glue the strips down, but be sparing with it, then if you need to pull the carpets up then it won't take much to pull them up. Then the main carpets I just simply placed down. Hope this helps!

And don't forget to loosen the kick plates so that you can get the carpet edge tucked neatly under them..........