Page 1 of 1
Ignition Light - quick tests
Posted: Sat Feb 08, 2014 6:03 pm
by mickeytwonames
I've a dynamo and the ignition lights stays on after start up- I've also changed the loom- any of you loominaries have any ideas what i should check first-my thanks for an hints.
Re: Ignition Light - quick tests
Posted: Sat Feb 08, 2014 6:33 pm
by MarkyB
Was it working OK before the new loom, anything else been changed?
Double check the connections against the wiring diagram and make sure the dynamo brushes are OK.
Re: Ignition Light - quick tests
Posted: Sun Feb 09, 2014 2:43 pm
by bmcecosse
As above, suspect the new loom ! Try with the dynamo disconnected - is the red light off ok then?
Re: Ignition Light - quick tests
Posted: Sun Feb 09, 2014 4:35 pm
by Ufudu
If all wiring checks out... try re-magnetising the dynamo....
Re: Ignition Light - quick tests
Posted: Sun Feb 09, 2014 7:46 pm
by bmcecosse
Certainly that could be the problem - if you have reversed the battery polarity???