Page 1 of 1
Where to cut
Posted: Wed Dec 11, 2013 10:39 pm
by Trafalgar blue
Can anyone give me a measurement so I can cut the bottom of the panel to the rear of my 2 door do I can gain access to the sill. The section looks ok so I'm hopeing to re-use it, but if it do need replacing I don't want to cut the panel too high. Thanks
Re: Where to cut
Posted: Thu Dec 12, 2013 8:44 am
by MarkyB
Not sure what you mean, have you removed the door step (sloped part)?
These should be held on with bolts along the bottom edge and self tapping screws on the top.
With the step off you can see the sill structure.
Re: Where to cut
Posted: Thu Dec 12, 2013 4:07 pm
by ian.mcdougall
Do you mean the external rear 1/4 panel / wing in front of the rear wheel.if so look inside to see how high to cut if you are reusing it or buy a replacement panel and see where to cut as you may have to replace the wing section anyway.
Re: Where to cut
Posted: Thu Dec 12, 2013 5:48 pm
by Trafalgar blue
Yes Ian that's the bit I mean, I don't want to cut it too high
Re: Where to cut
Posted: Thu Dec 12, 2013 8:26 pm
by Trafalgar blue
Well tonight I was able to get in the garage, so I decided to mark out & cut said panel[frame]
[/frame]
Re: Where to cut
Posted: Thu Dec 12, 2013 8:27 pm
by Trafalgar blue
Cut[frame]
[/frame]