Morris Minor Owners Club

Posted: **Tue May 07, 2013 9:16 pm**

Hi all

Just bought my first movie a 55 split screen and was putting a new carb and three branch manifold and I think one stud came. Out and will not go back in, so assume it has cross threaded.

can I run the car with one stud missing at the exhaust manifold?

Help much appreciated

Thanks

Gar

Posted: **Tue May 07, 2013 10:04 pm**

NO! What engine is in the car? Just fit a new stud - 5/16" unf thread. Often with a 3 branch - the two end studs are changed to bolts for ease of fitting....

Posted: **Tue May 07, 2013 10:14 pm**

Hi
It's a 998 with an unleaded head, I will look into your suggestion and thanks for the advice

Posted: **Tue May 07, 2013 10:16 pm**

Sorry was meant to say the stud missing was in the middle which ties in with the inlet manifold

Posted: **Tue May 07, 2013 11:29 pm**

998 ??? You NEED all the studs..... A '3 branch' exhaust is not going to benefit an otherwise standard 948 (??) engine - quite the opposite possibly......

Morris Minor Owners Club

Missing stud at manifold on engine block

Missing stud at manifold on engine block

Re: Missing stud at manifold on engine block

Re: Missing stud at manifold on engine block

Re: Missing stud at manifold on engine block

Re: Missing stud at manifold on engine block