Page 1 of 1

Ingnition light

Posted: Thu Jun 09, 2011 6:47 pm
by faversham999
Driving a 50 MPH no problems the ignition light comes stays on engine stops . Starter works but no engine power'

any ideas or other post i can look at

Re: Ingnition light

Posted: Thu Jun 09, 2011 8:12 pm
by bmcecosse
Starter works - no engine power? Do you mean - the starter turns the engine but it won't start? Is anything else electrical working - lights/horn ?? I suspect a wire has come off (or burned out) at the ignition switch - if lights etc still work, then it will be a white wire that's broken. If all electricals have failed - then look for a brown wire disconnected.

Re: Ingnition light

Posted: Thu Jun 09, 2011 11:12 pm
by Neil MG
Low tension wire come off the coil/distributer?

Re: Ingnition light

Posted: Thu Jun 09, 2011 11:53 pm
by bmcecosse
The red light wouldn't come on......at least not until the engine revs dropped low.

Re: Ingnition light

Posted: Fri Jun 10, 2011 9:12 am
by mike.perry
The engine revs would drop quickly if the coil was disconnected.

Re: Ingnition light

Posted: Fri Jun 10, 2011 1:52 pm
by bmcecosse
Yes - and the red light would glow until the dynamo stopped - hence my comment re wire off Ign switch etc, But need to know if anything else works!

Re: Ingnition light

Posted: Fri Jun 10, 2011 4:51 pm
by faversham999
Thanks all it was the coil very old conection its now new

Re: Ingnition light

Posted: Fri Jun 10, 2011 5:18 pm
by bmcecosse
Hopefully it wasn't the coil itself....... :-? just the connection ??? :)

Re: Ingnition light

Posted: Fri Jun 10, 2011 7:06 pm
by mike.perry
[frame]Image[/frame]
This was definately the coil, it blew the innards out.

Re: Ingnition light

Posted: Fri Jun 10, 2011 10:23 pm
by bmcecosse
Must have had a bump - allowing the oil to run out!

Re: Ingnition light

Posted: Sat Jun 11, 2011 11:24 pm
by Neil MG
This is not uncommon with these new Lucas coils...