Lowlight MM door bottoms?
Posted: Mon May 03, 2010 3:33 pm
Just a quick one.
I'm cutting out a small bit of grot at the bottom of the doors where water was trapped by a rubber seal mount. Is this area the same on later cars? It is a flat piece of steel with an almost 90 degree edge that folds under the bottom lip of the door skin. The panel on mine is made with only the one single fold, not several folds as shown in this other picture, plus it has a narrow C-shaped channel on it to hold a rubber seal strip.
http://morrisminorspares.co.uk/shop/pop ... p?pID=1281
Later repair panels from ESM show a different shaped panel, or is this pic showing 2 pieces welded together?
I'm cutting out a small bit of grot at the bottom of the doors where water was trapped by a rubber seal mount. Is this area the same on later cars? It is a flat piece of steel with an almost 90 degree edge that folds under the bottom lip of the door skin. The panel on mine is made with only the one single fold, not several folds as shown in this other picture, plus it has a narrow C-shaped channel on it to hold a rubber seal strip.
http://morrisminorspares.co.uk/shop/pop ... p?pID=1281
Later repair panels from ESM show a different shaped panel, or is this pic showing 2 pieces welded together?