Front suspension question.
Posted: Mon Jan 25, 2010 8:52 pm
Reference to parts diagram on page K.2 of the BL workshop manual.
Where part # 51, spigot pivot - rear, fits into part # 43 lower arm – rear, is it supposed to be a tight fit? Or just a slip fit?
I took the torsion bars out to repair the center cross-member, and on one side it was loose and on the other side it was tight, like pressed in.
TIA
Where part # 51, spigot pivot - rear, fits into part # 43 lower arm – rear, is it supposed to be a tight fit? Or just a slip fit?
I took the torsion bars out to repair the center cross-member, and on one side it was loose and on the other side it was tight, like pressed in.
TIA