Page 1 of 1
Help Needed
Posted: Thu Oct 18, 2007 5:49 pm
by smh582003
Can anyone help me or point me in the right direction on how to change the points on my morris 1000. I'm sure I can do it if I could just get an idea as to how.
Thanks
Steve
Posted: Thu Oct 18, 2007 5:51 pm
by smh582003
I should have said , Its the points on my fuel pump
Steve
Posted: Thu Oct 18, 2007 6:14 pm
by alex_holden
There are detailed instructions in the workshop manual. It's not difficult but to set the throwover point correctly you're supposed to split the body at the diaphragm, which might mean replacing the gasket between the two halves of the pump casting too. Also remember when screwing the body back together to energise the magnet before you tighten the screws.
Posted: Thu Oct 18, 2007 11:02 pm
by bmcecosse
You really do need to get hold of a Haynes manual - the SU pump reapair is detailed in many.