mrs.smith2012 wrote: ↑Thu Nov 19, 2026 11:35 am
The only thing that is really standing out to me right now is this thing… which I’m hoping someone can identify as I have no idea what it is… it appears to be some kind of aftermarket device that somebody has wired in. One wire runs down into the boot… I need to try and trace where it goes… the other appears to be wired into the brake light circuit?? What is this thing?
IMG_9367.jpeg
You've had some good guidance so far on this.
I've not taken part in this discussion so far, as I'm quite busy, but from the look of your photo the item resembles an electronic buzzer...
Back to your earlier photos of the wiring, I'd sum it all up as a bit of a mess, but not dramatically so.
Your car is a 1960.
That lower fuse box is correct for the year.
A Past Owner appears to have converted the car from Pull Start to Solenoid Start for some reason unbeknown to anyone but them.
(Key start was only introduced in 1964. Perhaps they wanted to use the Pull Start position for something else - it's the rightmost switch position of the 4)
Quite silly of them to take a screw out of the clamp for the cable harness to use as a hole for the Red cable.
The upper fusebox is simply a direct feed (Brown/White) from the live side of the Starter Solenoid. As such, it's can't be related to the problem you have at present, if only because it's nothing to do with the fuse which is blowing.
So what you have there is a non-fused permanent live, the one going down and through the screw hole, plus 3 fused outputs, the ones on the right in the photo.
Quite honestly if those are 35A fuses as used in the original fusebox, they might as well not be there because none of that wiring to the right looks capable of taking 35A
Additionally, that brown cable to the Starter Solenoid looks a bit thin to take the available output of an Alternator, Perhaps just the original feed from Dynamo to the Control Box that's been rerouted
It looks as though your alternator connections are via a bit of Chocolate Block tucked in behind the look.
As it's the lowermost fuse that is blowing I would disconnect and separate all 3 Green wires that are connected to that fuse, then use the Meter to see which is the negligable resistance measurement between wire end and earth.
Connect the other 2 back to the fuse and check the fuse doesn't blow.
The one that is still disconnected is the fault line and likely the brake one.