In photos below an HIF44 which has been refurbished. The question is whether the Throttle spindle lever is in the correct position. It seems to me to be in the wrong position for connecting the throttle cable if using the heat shield.
What do you think?
HIF 44 Assembly Question
Forum rules
By using this site, you agree to our rules. Please see: Terms of Use
By using this site, you agree to our rules. Please see: Terms of Use
-
- Minor Fan
- Posts: 268
- Joined: Sun Mar 14, 2010 9:06 pm
- MMOC Member: No
HIF 44 Assembly Question
- Attachments
-
- IMG_20221128_171224.jpg (640.26 KiB) Viewed 885 times
-
- IMG_20221128_171156.jpg (908.27 KiB) Viewed 885 times
-
- Minor Fan
- Posts: 476
- Joined: Thu May 11, 2017 8:23 pm
- Location: South Cheshire
- MMOC Member: Yes
Re: HIF 44 Assembly Question
Its on the wrong way round!
-
- Minor Fan
- Posts: 268
- Joined: Sun Mar 14, 2010 9:06 pm
- MMOC Member: No
Re: HIF 44 Assembly Question
So should be rotated 180 degrees anticlockwise?
-
- Minor Legend
- Posts: 1068
- Joined: Tue Nov 08, 2016 3:18 pm
- Location: Manchester ( Damp and Miserable ) and that's just the wife...
- MMOC Member: Yes
Re: HIF 44 Assembly Question
90 degrees anti-clockwise
John ;-)
John ;-)
-
- Minor Fan
- Posts: 268
- Joined: Sun Mar 14, 2010 9:06 pm
- MMOC Member: No
Re: HIF 44 Assembly Question
Looking at it I think cos of the "oblong" profile of the shaft it will only do 0 degrees and 180. I'll try and see.
-
- Minor Legend
- Posts: 1068
- Joined: Tue Nov 08, 2016 3:18 pm
- Location: Manchester ( Damp and Miserable ) and that's just the wife...
- MMOC Member: Yes
Re: HIF 44 Assembly Question
Your shaft seems to be in the same position as mine...
Could be the wrong throttle quadrant ,,,unless they have a " square" cutout?
John ;-)
Could be the wrong throttle quadrant ,,,unless they have a " square" cutout?
John ;-)
-
- Minor Fan
- Posts: 268
- Joined: Sun Mar 14, 2010 9:06 pm
- MMOC Member: No
Re: HIF 44 Assembly Question
I was able to knock back the tab washer on the throttle shaft, remove bolt, rotate quadrant 90 degrees and it's a much better fit, aligning with the mini type throttle cable mounting on the heat shield.
Would you run it with the heated manifold connected?
Would you run it with the heated manifold connected?