Hi,
Has anyone ever attempted to replace the mesh part of the sieve type oil strainer? I tried to buy one but it seems they are not available new and second hand ones seem to be in the same state as mine eg a hole in the bottom!!! I was just wondering before i remove the sump again if it is possible.
Cheers
Martyn
OIL Strainer
Forum rules
By using this site, you agree to our rules. Please see: Terms of Use
By using this site, you agree to our rules. Please see: Terms of Use
-
martylemoo
- Minor Fan
- Posts: 126
- Joined: Sun Apr 18, 2004 9:50 pm
- Location: Isle of Wight
- MMOC Member: No
-
rayofleamington
- Moderator
- Posts: 7679
- Joined: Fri Nov 01, 2002 2:55 pm
- Location: LEAMINGTON SPA
- MMOC Member: No
RE: OIL Strainer
I've never seen one with a hole in it (other than the intended holes)- so I reckon a second hand one would be the best way to go, as there must be a fair few out there without holes.
RE: OIL Strainer
You would need to solder a new bit of mesh over the hole - never tried it - not good with soldering !!
