ignition light remains on
Forum rules
By using this site, you agree to our rules. Please see: Terms of Use
By using this site, you agree to our rules. Please see: Terms of Use
ignition light remains on
After a short stop on my journey the battery was flat - I found a lead had come off the alternator (easy to put on). BUT I noticed although the ignition was turned off the ignition light was on. When I turned the key before pulling the starter the ignition light went off but the oil light came on. Usually when I do this both lights come on then go off when stated up. I jumped started car got it home turned ignition off pulled out key and ignition light remained on. The only thing I could do to stop this is removed alternator lead that had previously come off Can anyone give me advice please.
Re: ignition light remains on
Welcome to the forum! Which wire had come off the alternator? The large or the small? It rather sounds like an alternator fault has developed - possibly caused by running it with the wire disconnected, although I think that would be unusual. With the engine running and the wires connected , even though the light is on - is the alternator charging the battery? It should be showing 13.8 / 14 volts at decent revs.



Re: ignition light remains on
Thanks,It is the earth (green yellow) wire that had become detached. I have charged battery and it starts when I attach lead. It is just the issue of why does the ignition light remain on after turning off and removing key but go out when I turn ignition on?
Re: ignition light remains on
There is NO green/yellow wire to the alternator...... That's the oil pressure warning wire.... So I suggest you have the wires connected wrongly - what's connected to the oil pressure switch ?????? I hope you haven't ruined the alternator - it 'should' be ok......fingers crossed !



-
- Minor Fan
- Posts: 472
- Joined: Mon Nov 18, 2013 11:07 am
- Location: Oxfordshire
- MMOC Member: No
Re: ignition light remains on
Unless someone has fitted an alternator using domestic earth wire....
Glad to be back!
Re: ignition light remains on
Thank you it has now been sorted - hopefully that will be end of problem. It was connected incorrectly!!