Clunking noise

Discuss mechanical problems here.
Forum rules
By using this site, you agree to our rules. Please see: Terms of Use
Post Reply
KyleMorrisEvans92
Minor Friendly
Posts: 99
Joined: Mon Aug 01, 2011 8:10 pm
MMOC Member: No

Clunking noise

Post by KyleMorrisEvans92 »

Hello, My right hand wheel had developed a clunking noise when I go over small bumps, could any of you tell me what it could be and how to resolve it. I have tightened the wheel nuts and it still happens. Is the car safe to drive ?

Thanks
bmcecosse
Minor Maniac
Posts: 46561
Joined: Wed Feb 16, 2005 11:24 pm
Location: ML9
MMOC Member: No

Re: Clunking noise

Post by bmcecosse »

Highly likely that the bottom trunnion is desperately loose on the kingpin - and is about to part company with it - allowing the wheel to buckle under the car.... I would VERY urgently examine it - and everything else on the front suspension - including the tightness of the 4 bolts holding the front damper in place on the crossmember - inside the engine compartment.
ImageImage
Image
KyleMorrisEvans92
Minor Friendly
Posts: 99
Joined: Mon Aug 01, 2011 8:10 pm
MMOC Member: No

Re: Clunking noise

Post by KyleMorrisEvans92 »

Thank you, I will sort it tomorrow, I wont be driving it until its done :(
KyleMorrisEvans92
Minor Friendly
Posts: 99
Joined: Mon Aug 01, 2011 8:10 pm
MMOC Member: No

Re: Clunking noise

Post by KyleMorrisEvans92 »

It turns out it was a simple job, as you said it was the 4 bolts that hold the dampers on in the engine bay. I got about 5 full turns out of each bolt. Tightened them up and problem cured.

Thanks for the advice

Kyle Evans
JOWETTJAVELIN
Minor Legend
Posts: 2775
Joined: Mon Dec 12, 2011 7:20 pm
Location: LANCASHIRE (paradise)
MMOC Member: Yes

Re: Clunking noise

Post by JOWETTJAVELIN »

Now grease the trunnions to avoid the other possible problem bmc mentioned.
bmcecosse
Minor Maniac
Posts: 46561
Joined: Wed Feb 16, 2005 11:24 pm
Location: ML9
MMOC Member: No

Re: Clunking noise

Post by bmcecosse »

Hmmmmm - 5 full turns , or 5 flats? If really was 5 full turns I would be concerned about the bolts - and very tempted to fit a full new set of bolts..........
ImageImage
Image
Post Reply