Hi,
Being lazy here and also try to build on others experience. I am using gas mix and assuming metal is good has anyone welded using the Clarke and can you remember approx settings?
Many thanks
Mig welder Clarke 90 en
Forum rules
By using this site, you agree to our rules. Please see: Terms of Use
By using this site, you agree to our rules. Please see: Terms of Use
-
- Minor Friendly
- Posts: 64
- Joined: Mon Dec 01, 2008 8:39 pm
- MMOC Member: No
-
- Minor Legend
- Posts: 3798
- Joined: Tue Jul 25, 2006 9:46 am
- Location: Burnley
- MMOC Member: No
Re: Mig welder Clarke 90 en
It depends on so many different factors, you should really inspect the back of the weld for penetration if at all possible.


Alex Holden - http://www.alexholden.net/
If it doesn't work, you're not hitting it with a big enough hammer.
Re: Mig welder Clarke 90 en
I think I generally use the max-1 power setting to get adequate penetration without blowing holes and wire speed around 7/10 if I remember correctly. The thicker chassis sections will probably take full power. That's with gasless operation though.
Best approach is to practise on some scrap of the same thickness first though. + what Alex said.
Best approach is to practise on some scrap of the same thickness first though. + what Alex said.