quarterlight

Post by **les** » Wed Aug 19, 2009 10:15 pm

I've dismantled a quarterlight, removing the glass and rubber insert. When it's reassembled what holds the glass firmly in place?

Post by **bmcecosse** » Wed Aug 19, 2009 10:16 pm

The very tight fit of the rubber and the frame ! I understand they are very difficult to re-assemble!

Post by **les** » Wed Aug 19, 2009 10:18 pm

You answered that nearly before I posted the question!!!!

Post by **alanworland** » Wed Aug 19, 2009 10:53 pm

Until I got hold of a pair of new old stock quarter lights I was going to stick the glass into the frames with a black neutral cure silicone rubber. I dont think the seals are available.

Post by **les** » Thu Aug 20, 2009 9:32 pm

Fortunately I have a decent seal, but I should imagine 'suspending' the glass in a silicone bed would be an alternative. It would be easier to assemble, certainly worth bearing in mind if the glass is not held firm.

Post by **hotrodder13** » Thu Aug 20, 2009 9:44 pm

they are available i got a new set from esm.

Post by **aupickup** » Fri Aug 21, 2009 6:34 pm

are teh esm ones the correct profile

Post by **hotrodder13** » Fri Aug 21, 2009 7:16 pm

not tryed them yet