OK I give up what is the trick?

Post by **246gts** » Fri Jun 16, 2006 9:35 pm

What is the trick of getting the rubber grommets below the wiper motor into place?
I've tried fairy liquid, cutting a small notch and trying to screw them in, poking with a blunt screwdriver and now it looks like I will have to cut them into two halves and put one on top and one below and put the bolt through.
HELP
Dave

Post by **aupickup** » Fri Jun 16, 2006 9:40 pm

perseverance is the key here.
well what i have done in the past (original rubbers) is to get them 2/3rds of the way in and then with a blunt instrument a wooden wedge is good, just prise the last 1/3rd in, it will go

Post by **NZJLY** » Fri Jun 16, 2006 10:42 pm

There are rubber bits under there

?

Post by **aupickup** » Fri Jun 16, 2006 10:46 pm

yes they are one peice rubbers with a slot in the middle that goes over and under the metal, if that makes sense

Post by **Multiphonikks** » Sat Jun 17, 2006 8:41 am

Thanks for this post! I was taking Hebe's old ones off the other day and thinking "How on earth do I put these back?". Au - do you heat the rubbers up first?

Post by **rayofleamington** » Sat Jun 17, 2006 12:50 pm

I've only ever used a blunt instrument - and maybe some WD40 to help slipperyness.

Post by **Willie** » Sat Jun 17, 2006 7:40 pm

Be careful with these rubbers the object is to insulate the wiper motor so that
it is NOT connected to chassis!

Post by **246gts** » Sat Jun 17, 2006 8:18 pm

Done it!
It was a case of perseverance, cut a small notch in the underside, screw it in as far as you can, use a blunt instrument in my case an old wooden spoon handle cut to a blunt point, push the rubber in as you twist around and dont forget the fairy liquid!!!
These new ones were from MGM spares and to be honest without the modification I would say there was no chance
The other tip was to leave it alone last bnight and come to it fresh this morning or they would have been cut into two separate halves!
Dave.

Post by **NZJLY** » Sat Jun 17, 2006 11:01 pm

rayofleamington wrote:I've only ever used a blunt instrument

but where do you hide the bodies

Seriously though, if it earths via the body, what happens? After 40 years there must be a few that have no rubber.
John

Post by **Welung666** » Sat Jun 17, 2006 11:06 pm

NZJLY wrote:Seriously though, if it earths via the body, what happens?

Fizz, spark, bang probably

Lee

Post by **NZJLY** » Sat Jun 17, 2006 11:11 pm

Hmmm guess that means I have rubber

:):):):)
John

Post by **lowedb** » Mon Jun 19, 2006 1:37 pm

It's to insulate it as far as vibration, not for electrical insulation.