Morris Minor Owners Club

Thanks for the quick reply. Still a bit nervous about making connections. Can you elaborate on exactly where you insert the cables. Clock has short leads on it which would obviously need extended. Heard about electrical fires and want to be certain I am connecting properly. Thanks

Hi. Would like some advice on wiring a clock. have purchased Kienzle clock 12V Neg earth for my Minor. Proposing to mount it below the heater casing. Car is negative earth. Clock has purple spade connection marked +, black spade connection marked - and spring-loaded push in bulb cable into circular ...

If you have fitted the sender in the wrong position into the tank it can be prevented from rising high enough to read 'full' when it should do. Looking from the rear of the car the sender units terminal should be on the left hand side. thanks Rob and Williefor comments. Have just checked position o...

Thanks Dale for your reply.I have since removed,cleaned and replaced th sender unit.Gauge is showing half full now when car seems to have more fuel than that.Looks like I need a new one.

Hi. Hopefully somebody can help!. The fuel gauge on my 1967 Minor Saloon seems to be faulty. It works when tank is half full or less. However when filling tank the gauge shows empty. Not until the petrol runs low and you go over a ramp / bump the gauge registers again. Could this be a sticking float...

No comments about wire pulling in the garage please

Andrew is right. Its the LH fuse as viewed under the bonnet in small fuse box. We found it to be a dirty fuse. Only seems to affect the interior light and horn. On line comments saved a lot of swearing and unessary wire pulling. And its brass monkeys in the garage

Thanks for earlier comments. I found fuse and repaired the fault. Most grateful. No doubt I will be asking for further advice in the future

Hello all i am new to this message board. Just acquired Moggie and looking for some advice on fuses. The interior light and horn not working. The wiring diagram shows a fuselink on this circuit. However I am having problems locating said fuse. Both were working prior to easing the interior light swi...