Page 1 of 1
Water Pump Morris 1000
Posted: Tue Feb 21, 2006 4:36 pm
by Arfron
Does anyone know if the pipe fitting which
screws into the water pump ,is the same thread /size which fits into the block ? ( By-pass hose screw - in fittings )
I can see the
' block ' threaded connector on the ESM site , but I need one to fit into the pump , ' cos ' mine is somewhat rotted , but pump is fine !!
Arfron
Posted: Tue Feb 21, 2006 4:50 pm
by Kevin
I would have thought that if that part has rotted the rest of the pump is probably on its last legs, they are fairly cheap anyway, around £15 if I remember, also a good time to renwew the bypass hose as well with a piece of heater hose at the same time.
Posted: Tue Feb 21, 2006 7:14 pm
by bmcecosse
I really don't know - but I suspect you will have a terrible job trying to get the old fitting out of the pump. Pumps are not dear - i bought a new one on ebay recently for £1.99 !
Water Pump
Posted: Wed Feb 22, 2006 9:12 am
by Arfron
Thanks for the repllies Kevin + and bmcecosse . Strangely enough the fitting came out fairly easily -- Plus gas + a few grunt using a vice !!
On reflection though --a new pump seems sensible especially if I can get one for £1.99. It must be cheaper in Ecosse ??
Regards
Arfron
Posted: Wed Feb 22, 2006 2:44 pm
by janstolp
I bought one last week here in Holland ,direct of the shelf for about the same money as you all mentioned.Guess whatThe motor is a lot more silent.You had better go for a new pump.
Pump
Posted: Wed Feb 22, 2006 7:48 pm
by Arfron
Ok guys point taken. Cheers
Arfron