fitting the loom

Discuss Electrical problems here.
Forum rules
By using this site, you agree to our rules. Please see: Terms of Use
Post Reply
SR
Minor Addict
Posts: 641
Joined: Thu Aug 19, 2004 9:47 pm
Location: kent [south]
MMOC Member: No

fitting the loom

Post by SR »

anyone got tips or advice on fitting the loom, just looking at it gives me a headache, got one made for the last moggys 1971, so its got indicators ,alternator ect..., but i want to keep the pull start and run flashers off trafficator switch, traffys will be sealed around their edges with black mastic so not i9n use,cheers steve :-?
Image
Image
http://www.villagephotos.com/pubbrowse.asp?folder_id=1070767
Top
Cam
Moderator
Moderator
Posts: 5109
Joined: Mon May 20, 2002 1:00 am
Location: Stoke-on-Trent, Staffordshire, UK
MMOC Member: No

Post by Cam »

Nice piccies Steve! Best bet with a loom is to start at the big hole where it goes through the bulkhead (widest part of the loom), then run the wires into place (behind dash, under car, into engine bay, etc) Then connect up! Sounds easy doesn't it? :wink:
Top
aupickup
Minor Maniac
Posts: 6004
Joined: Tue Jul 20, 2004 11:41 pm
Location: lanark
MMOC Member: No

Post by aupickup »

thats the way i re wired my van, took all of 4 hours , if you are methodical and identify with the wiring diagrams it all becomes quite clear, there are obvious connections, do these first and then sort out the ones you are not sure of
Top
Post Reply

Return to “Electrical”