Page 1 of 1
Rear damper link arm nut size
Posted: Sun Oct 09, 2005 10:01 pm
by Cam
Having bought a new rear chassis rail section from ESM, I need to bolt the rear damper link arm to it. The original nut was a castle type, but the new pin has no hole for the split-pin, so I'm going to have to use a nyloc.
Any idea what size they are?
This is what I'm on about:
Posted: Sun Oct 09, 2005 11:41 pm
by Matt
why not put the nut on and drill a hole for a split pin?
Posted: Sun Oct 09, 2005 11:44 pm
by Cam
Cause it's a tiny hole and drill and the chances of coming out the other side in the right place are virtually nill. Maybe if I had it in the vice and on a drill jig I might get away with it, but it's welded on the car now and I don't have time to waste mucking about when a nyloc will do the job. If no-one knows, then I'll just put the castle nut back on for the time being. It's not like the shocker link arm comes off easily anyway.
Posted: Sun Oct 09, 2005 11:45 pm
by Matt
use thread loc if you can't find a nyloc though!
Posted: Sun Oct 09, 2005 11:46 pm
by Cam
Good idea! I've got some knocking about somewhere.
Posted: Mon Oct 10, 2005 1:42 pm
by bmcecosse
Put two nuts on - locked together.
nut
Posted: Mon Oct 10, 2005 6:55 pm
by Willie
CAM it is 3/8 BSF. ( I know because I had to farm out the job because
I couldn't locate a 3/8 BSF die).
Posted: Mon Oct 10, 2005 8:04 pm
by Cam
Thank you Willie, you are a gent.