What unf bolts do I need to bolt the engine to engine stand
Posted: Wed Nov 04, 2026 3:51 pm
Hi there people, I recently bought an used a series engine to strip down and rebuild and learn along the way
I have bought an engine stand for it off eBay
Upon inspection it may be a 1098cc a series engines parts as it doesn’t have the 950stamped on the side of the block
The owner said he took it out of a 1968 Austin pickup which sadly was scrapped and they use the same engine it has the later heater thing on the back of the cylinder head not the brass tap like on my 948cc engine in my 1959 4 door.
I just need to buy 4 long bolts 70-80mm length to go through the bracket of the engine stand to the engine
But not sure on the thread which I want to bolt it where the gearbox would bolt to if that makes sense
Any ideas are welcome please
I have bought an engine stand for it off eBay
Upon inspection it may be a 1098cc a series engines parts as it doesn’t have the 950stamped on the side of the block
The owner said he took it out of a 1968 Austin pickup which sadly was scrapped and they use the same engine it has the later heater thing on the back of the cylinder head not the brass tap like on my 948cc engine in my 1959 4 door.
I just need to buy 4 long bolts 70-80mm length to go through the bracket of the engine stand to the engine
But not sure on the thread which I want to bolt it where the gearbox would bolt to if that makes sense
Any ideas are welcome please