Problem getting front hub onto axle.
Posted: Wed Jun 18, 2025 5:56 pm
I am refitting the O/S front hub (Marina disc conversion) and have fitted new taper roller bearings and tapped in the new bearing outer races so they appeared to be fully home. I am using the axle nut to wind it back on and although the same procedure on the N/S went smoothly, this side has reached a point where there is still about 5mm to go until it is fully home, but it just wont go. I have tightened the nut as much as I dare and do not wish to strip the thread if I apply more pressure. I may have to take it off and have another look, but wondered if I am doing something wrong? Could the outer races need to go in further?