Morris Minor Owners Club

Fitted a wooden wheel to my 57 saloon, with the horn push on the indicator stalk. Now fitting same wheel to my 68 saloon, horn push in the centre of the wheel. Ordered a alloy horn push, arrived without instructions. There are two wires on the horn push, does anyone have any ideas of how to fit it? My steering column has a spring in the middle underneath the original horn push, horn is pushed contact made and horn sounds. The new horn push does not clear the spring so horn sounds all the time. Do I remove the spring ? Any ideas.

In the standard installation the contact on the bottom of the horn push is always in contact with the bullet terminated wire that is held in with a c-clip to the spring. The circuit is completed by pressing the horn push inner which completes the circuit between the centre steering column wire and the wire that connects via a “shoe” contact on the indicator assembly and the slip ring on the steering column. What I am trying to say is that the horn push is a switch and it does not operate by making and breaking contact with the centre steering column wire.


Stephen

The horn push in the centre of the wheel operates the horn, but the replacement horn push will not fit because of the spring. Any ideas ?

A photo of the back of the horn push would help.

The spring is around an insulting tube like this: https://www.morrisminorspares.com/elect ... g-p1238931

Without really understanding what the problem is, could you shorten the spring or try without it?

Stephen

The alloy horn push will not fit as the spring is in the way, there are also two wires on the back of the horn push with no instructions it's not clear as to what to do.