Page 1 of 1
Rear Wiring Loom Routing on a Traveller
Posted: Wed Jun 29, 2022 2:06 pm
by culp
Hello, I'm just in the process of finishing the rear wiring on my 1970 Traveller.
- rear wiring 1970 traveller
- PXL_20220629_130010120.jpg (769.11 KiB) Viewed 658 times
I have 2 P clips to go back on, but no reference as to were to put them, or whether I have got this wiring right as it looks a bit untidy. Can anyone advise please?
Re: Rear Wiring Loom Routing on a Traveller
Posted: Wed Jun 29, 2022 2:42 pm
by simmitc
If they are the large metal ones with rubber inserts, then they attach to the bumper mounting iron.
Re: Rear Wiring Loom Routing on a Traveller
Posted: Wed Jun 29, 2022 4:58 pm
by culp
Thanks is it the bolt that goes vertically through the floor pan, or one of the two that fit horizontally to the metal bracket
Re: Rear Wiring Loom Routing on a Traveller
Posted: Wed Jun 29, 2022 5:37 pm
by simmitc
The top horizontal one is normal, but in truth, any would do unless you're looking for concours.
Re: Rear Wiring Loom Routing on a Traveller
Posted: Wed Jun 29, 2022 6:54 pm
by JOWETTJAVELIN
Yes, be sure the P clips are either rubber covered or bell-mouthed metal. You will find the wiring to the near side lights tucks neatly in the recess immediately behind the lower panel.