Fitting an exterior sun visor.
Posted: Wed Mar 09, 2022 11:20 am
Ideally you should have two people fitting.
1. Offer up the visor to the car and mark the fitting holes with masking tape and pencil.
2. Fit top clamps in position on guttering in line with the hole marks and tighten the clamp plate screws.
3. Offer up the visor and secure to the clamps with the bolts.
4. Brace between the front edge of the visor and the bonnet with a length of timber and cloths to avoid scratching the paint.
5. Slide the remaining two clamps up into position behind the visor and fasten as in 2 & 3.
6. Check visor is level looking at the front of the car and carefully tap clamps up or down as necessary.
7. Check and fully tighten all fixings.
1. Offer up the visor to the car and mark the fitting holes with masking tape and pencil.
2. Fit top clamps in position on guttering in line with the hole marks and tighten the clamp plate screws.
3. Offer up the visor and secure to the clamps with the bolts.
4. Brace between the front edge of the visor and the bonnet with a length of timber and cloths to avoid scratching the paint.
5. Slide the remaining two clamps up into position behind the visor and fasten as in 2 & 3.
6. Check visor is level looking at the front of the car and carefully tap clamps up or down as necessary.
7. Check and fully tighten all fixings.