Page 1 of 1
Help for the SU pump
Posted: Sun Jan 30, 2022 5:36 pm
by Sandun
Hi , friends.
My SU fuel Pump does not stop working if the fill flot from fuel , it change to speed low but not stop - second by second sound " tik .... tik "
I have seen some pump totaly stop working when flot fill.
Where the Problem ?
Regards
Sandun.
Re: Help for the SU pump
Posted: Sun Jan 30, 2022 5:41 pm
by unclealec
Either you need a new float valve in the carb, or new valves in the pump, or the pump diaphragm has sprung a leak.
Re: Help for the SU pump
Posted: Mon Jan 31, 2022 9:52 pm
by Philip b
rebuild it...it's easy
Re: Help for the SU pump
Posted: Tue Feb 01, 2022 9:44 am
by myoldjalopy
Usually it is dirt in the float valve, or a worn valve that causes this. Or the float itself has sprung a leak so it doesn't close the valve (not uncommon on the old brass floats). I would check the float unit first, beore pulling the pump to bits.....
Re: Help for the SU pump
Posted: Tue Feb 01, 2022 10:29 am
by simmitc
Observe all precautions for dealing with petrol - good ventilation, no sparks, suitable container etc.
Remove the end of the flexible fuel pipe from the carburettor and direct into a container. Switch on the ignition, observe petrol flowing into the container. Place your thumb firmly over the end of the pipe to make a seal. If the pump stops ticking then that is OK and the problem is in the carb - valve or float. If the pump continues to click when no petrol is flowing, then it is a problem in the pump. Switch off ignition, reconnect the pipe and pour the petrol back into the tank.
At least you will now know which item needs attention.
Re: Help for the SU pump
Posted: Wed Feb 02, 2022 11:43 am
by Sandun
Thank you very much to all .