Morris Minor Owners Club

Hi everyone and a Merry Christmas and a better New Year hopefully
I am trying to finish off my Traveller Resto and coming to try and fit the Aluminium Rain/roof gutter and was wondering if anyone could give me any advice.
Also does anyone have the measurement from the B Post to the corner to put the cut out and how long it should be to get it round the corner .
Cheers and appreciated Paul (Bubblemechanic)

You need the traveller timber drawings.... AFA858 is one the cutout is where the timber is radiused and 1/16 " radius is used on the aly corners....the drawings also detail the nails used the correct gap at the rubber seal etc... here is a snapshot view which I have copied for you as its Christmas!
Taupe

Thank Appreciated but still missing the measurements from the edge of the cabin rain gutter to the first cut
Then the length of the cut to allow for Bending
Like the Drawing where can I get the Drawings you mentioned
Cheers Paul (Bubblemechanic)

Just use a tape measure to measure the length of the radius part on your timber or from the roof joint if you prefer? This will vary slightly with each car depending on the radius used on the timber...

Ray Newells Morris Traveller book shows loads of pics of it being fitted too and indicates a cut out of around 25-30mmwhich is about right

T

Thank you simple when you put it that way am trying to overthink the job I think
P (B) Have A Nice Christmas and a better year than this one.

Please post some pics when you do the job as it will be helpful to me when I do similar sometime next year.

Thanks

Will Do Cheers