Page 1 of 1

Indicator stalk repair

Posted: Wed Aug 18, 2021 9:26 am
by Grumpy21
I’ve had a look at the search and can’t find anyone who has attempted to repair the stalk.

Mine was working ok turning left but infrequently turning right, a little jiggling got it to work. It’s progressively worsened to the point where it rarely works at all now in either direction.

I assume there some type of wiper that makes contact with perhaps copper ‘blobs’ at the ends of the wires. These may well have worn or corroded

I’d rather try to repair than replace if possible

Thanks

Re: Indicator stalk repair

Posted: Wed Aug 18, 2021 3:17 pm
by Sleeper
Is it like this....
20190301_161918.jpg
20190301_161918.jpg (1.58 MiB) Viewed 1380 times
Sorry but it's the only piccie I have of it, after altering the " tell-tale " lamp , but you can see the problems with old wiring and old solder..


John ;-)

Re: Indicator stalk repair

Posted: Wed Aug 18, 2021 6:14 pm
by Grumpy21
Thanks John. Not the same as yours but I’ve traced what I think is the problem. The live feed connector was very frayed with only one or two filaments still intact. I can only assume that the current was simply too much for the flimsy wire to conduct to the flasher unit. Wiring restored and all is well. I subsequently fitted a solid state flasher relay in preparation for converting to led indicator bulbs. Again all working well and brighter than before too

Cheers

Gary