Low Light Headlamp Parts
Posted: Thu Jul 15, 2021 1:20 pm
On the 5 3/4" rims of the lowlight headlamps there are two pressed in holes - one either side that the lamp pivots on, is there supposed to be inserts in them?
Cheers
Cheers
Ah - found the above - I imagine that these rubbers aren't available - any body recommend something else to use?RobThomas wrote: ↑Sun Oct 02, 2016 11:23 am One side of the chrome ring has a rubber insert that swivels on the pin stuck in the outer edge of the lamp hole in the front panel. The inboard side of the chrome has a similar swivel but on a bracket that can slide fore-aft along the track welded to the inboard edge of the front panel and is clamped by a 2BA nut+bolt (I think that was the size?). The up-down is adjusted by the long screw thread in an obvious way although the thread is 180 degrees out in those pics. It enters the bodywork through a small hole below the lamp aperture, from the front.