Can anyone advise me how best to do this? Are there any specific jacking points on the underside of the car, or is this chassis sufficiently solid to be able to jack up and place an axle stand 'roughly' in each corner?
Please advise

Thank you!!!philthehill wrote: ↑Wed Jan 06, 2021 3:44 pm I also would not bother about raising the car off the ground until you are ready to undertake the restoration.
But if you want to jack up the car and support off the ground:-
At the rear........Jack under the diff and raise until you can get a pair of axle stands under the axle tube as near to the springs as possible.
At the front.......Jack under the front cross member with a piece of wood between jack and cross member. Make sure that the jack wheels are in the fore and aft position as the jack will move as the jack is raised. When high enough place axle stands under the chassis legs in the area of the eye bolt. Again use a piece of wood between axle stand and chassis leg to spread the load.
Use axle stands with a flat middle section for the support. Halfords 3 ton axle stands are very suitable and are the ones my Minor is currently supported on off the ground.
https://www.halfords.com/tools/garage-w ... 57123.html
People who live in Toxteth, or anywhere else, for that matter, can already have a ‘set of wheels’ so thieves can travel.