Gearbox 3rd Shaft Thrust Washer
Posted: Sat Jul 18, 2020 11:51 am
Hi
I cannot find any documentation to give me a clue what thickness of washer I should use. They come in various oversizes.
I am guessing that I need to set the 3rd shaft gear cluster end float to .001-.003" the same as the laygear.
Does anyone know where to find any information on that please. There is nothing in AKD530
Thanks
Phil
I cannot find any documentation to give me a clue what thickness of washer I should use. They come in various oversizes.
I am guessing that I need to set the 3rd shaft gear cluster end float to .001-.003" the same as the laygear.
Does anyone know where to find any information on that please. There is nothing in AKD530
Thanks
Phil