Morris Minor Owners Club

Hello,

Does anyone have any handy tips for getting the front hubs back on?

New bearings just fitted and so not too keen on my usual go-to of hit it with a hammer - it just needs a bit of "persuasion"!

Many thanks

Provided the shaft and inner part of the bearings are clean and burr free, the hubs should be a good fit and able to be pushed on.

Are they good qualuty correct bearings? as above, if all clean then a push should be all that's needed.

Thanks gents.

I am relegating the hammer back to the shed

As the other replies, re the hub, but a suggestion to the OP: Promote the mallet to your ‘go-to’ tool instead of a hammer.

There are not many tasks that actually require a hammer.

except track rod ends used to hit the fancy tool as well