Morris Minor Owners Club

When fitting a 1275 Marina engine in a Morris Minor , the thermostat housing and the top radiator out let, are at a poor angle , resulting in the top hose being bent at quite a severe angle ,which doesn’t look good and is not good re engine movement . Is there another alloy housing which is more compatible ? Or do I cut and weld an original shaped one ?

Gary

Brilliant ,just what I needed !

Gary

You can use one from an MGB

Thanks Paul .

There are at least three different thermostat housings fitted to the MGB.

I suspect that the one mentioned above is the following as it looks very similar to the one listed in my post above.

https://www.moss-europe.co.uk/housing-t ... soc=109789

https://www.ebay.co.uk/itm/MG-NEW-MGB-T ... XQQJBQ6dox

Whilst the MGB thermostat housing may fit the angle of the outlet does not look right compared to the DMG item.
To compound my concerns I have a NOS MGB thermostat housing Pt No: 12H2447 and offering it up to the 1275cc cylinder head it does not appear to be at the right angle to meet the Minor radiator inlet.
This is the type of NOS thermostat housing I have used to compare:-
https://www.ebay.co.uk/itm/Mgb-Thermost ... Sw35Be522F

This is what is fitted to mine https://www.ebay.co.uk/itm/Thermostat-H ... %7Ciid%3A1

Edit: I also galvanized the studs to prevent the alloy corroding and enlarged the holes slightly.

i do the same. i run a slightly larger drill bit through the holes. I also use stainless bolts (not studs) and anti-seize paste (food grade).

I'm just bought one of those stat housings. Thanks.