Page 1 of 1
Brake and clutch pedal return springs, where attached
Posted: Thu Jun 18, 2020 4:49 pm
by Michiel
Around the brake and clutch pedals there are three identical looking return springs.
1. I know there is one between the clutch fork and a hole in the rear engine plate.
2. One from the exhaust clamp to where? A clevis pin? But which?
3. One from the master cylinder yoke to where?
I don 't remember. It was a year ago when I did take photo's, but not from these springs...
Re: Brake and clutch pedal return springs, where attached
Posted: Thu Jun 18, 2020 4:57 pm
by dudload
Michiel wrote: ↑Thu Jun 18, 2020 4:49 pm
Around the brake and clutch pedals there are three identical looking return springs.
1. I know there is one between the clutch fork and a hole in the rear engine plate.
2. One from the exhaust clamp to where? A clevis pin? But which? One goes from the exhaust clamp to the accelerator yoke. This is the other part of the carb that doesn't have a cable going into it. (The choke should have a cable going into it already)
3. One from the master cylinder yoke to where? Assume you mean the brake pedal here? The spring goes to a small plate inside the chassis leg, and the other end to the brake pedal
I don 't remember. It was a year ago when I did take photo's, but not from these springs...
i've answered you're questions above!
Re: Brake and clutch pedal return springs, where attached
Posted: Thu Jun 18, 2020 5:05 pm
by Michiel
It is a new chassis leg, no plate inside. I will make one. Thanks Dudload.
Re: Brake and clutch pedal return springs, where attached
Posted: Thu Jun 18, 2020 5:17 pm
by les
Unusual not to have the spring fixing plate in the leg, makes you wonder if it got missed in production, it needs to be in the right place.
Re: Brake and clutch pedal return springs, where attached
Posted: Thu Jun 18, 2020 5:41 pm
by Michiel
LMC Hadrian and otherwise an absolute good leg...