Morris Minor Owners Club

Hi all
One of my Moggies has a rotten rear floor, but not the area where peoples feet go (you can get panels for there easily enough) but back from the cross box under the rear seat, round front rear spring hanger and right across into the transmission tunnel, all on the drivers sidde. Basically a huge area is all just holes and underseal. The rest of the floor is fine, nothing wrong with that. I have the spring hanger on a plate but the rot is over a far larger area than this covers. Does anyone know of any pressings for that whole area? I couldnt find any.

hallo dave, i dont know about pressings,but having just replaced f/ward spring hanger and gone through a migraine placing correctly hanger plate be warned do not lose rivet holes in floor under rear seat,datum points. re, john.

Made these areas with a hammerform

volrod544 wrote: ↑Wed Feb 10, 2021 6:37 pm Made these areas with a hammerform

That's awesome.. I may have a go at hammer forming some of my panels. I guess the hardest part is the dimensions of the form?

Similar technique, albeit using a couple of flat bits of steel sheet instead of a properly dimensioned template.