Page 1 of 1
Pop the series 2 side lights
Posted: Thu Apr 02, 2020 10:53 am
by markattard
Is there an easy way to pop these in place please?
Re: Pop the series 2 side lights
Posted: Thu Apr 02, 2020 11:04 am
by geoberni
Is this not a continuation of your earlier question about SII front lights..?
viewtopic.php?f=11&t=71593
I thought ManyMinors gave a quite detailed and illustrated explanation on that page.
Re: Pop the series 2 side lights
Posted: Thu Apr 02, 2020 12:45 pm
by myoldjalopy
He did. Maybe the OP's replacements are inferior quality, as was suggested as a possible reason at the time.....
It may be necessary to prise the rubber away to get the lamp cover to clip into the holder and then go round easing the rubber over its lip.
Re: Pop the series 2 side lights
Posted: Thu Apr 02, 2020 4:30 pm
by markattard
Thank you all! These are brand new replacement parts from esm. There was a slight excessive pressure at the prongs inside the holder had to prise them just a little and job done. You always have to make sure it fits before it's installed to make sure it fits when installed. Lesson learnt... for the next few days....
Re: Pop the series 2 side lights
Posted: Thu Apr 02, 2020 5:17 pm
by myoldjalopy
Well done. Nice surPRISE for you!
