Removing boot lock barrel - Step by Step Guide - Part 3
Posted: Mon May 06, 2019 1:49 am
The cleaned up lock bolt was then replaced in the assembly
and the barrel retaining pin punched back in.
Next, reassemble the handel. washer, spiral spring an cowl in the order that they were removed in.
Jam the whole assembly back in teh vice to push the cowl past the filed off shaft "wings"
I then decided to drill the retaining roll-pin hole on the other set of flats to preserve the stampings.
If you don't have access to roll-pins, use anything else that can be punched into whatever diameter hole you decide to drill.
Hole drilling in progress
Hole drilling completed and ready for roll-pin (retaining pin) insertion
- 10-Cleaned up lock bolt refitted.jpg (641.61 KiB) Viewed 576 times
Next, reassemble the handel. washer, spiral spring an cowl in the order that they were removed in.
Jam the whole assembly back in teh vice to push the cowl past the filed off shaft "wings"
- 11-Reassembled handle jammed in vice.jpg (355.94 KiB) Viewed 576 times
- 12-Shaft ready for drilling to fit roll-pin.jpg (638.35 KiB) Viewed 576 times
- 13-Drilling started.jpg (431.65 KiB) Viewed 576 times
- 14-Drill swarf.jpg (488.24 KiB) Viewed 576 times