Page 1 of 1
Front door stay screw plate
Posted: Wed May 10, 2017 9:03 pm
by Johnny
Would anyone have an idea where I might be able to get one of the small plates that weld to the rear of the front inner wing panel that takes the screws for the door stay?
I have managed to loose the one I took off of the old panel and it's causing a major hold up now. It goes behind the two holes in the centre. Any advice would be most appreciated.
Thanks!
Re: Front door stay screw plate
Posted: Wed May 10, 2017 9:04 pm
by Johnny
I don't have a tap and die set either or I'd make one!
Re: Front door stay screw plate
Posted: Wed May 10, 2017 9:09 pm
by les
Might have a struggle there, two alternatives spring to mind. (1)make a plate. (2)fit the stay to the panel with the screws and appropriate nuts, then weld the two nuts to the back of the panel?
edit. Forget the first option then, I posted then saw your follow up message! you could though make a plate and weld nuts to that.
Re: Front door stay screw plate
Posted: Wed May 10, 2017 9:35 pm
by Johnny
Thanks Les, I think I'm just going to have to do that...
It's just one of those annoying little jobs that holds everything up!
All the best
Re: Front door stay screw plate
Posted: Sat May 13, 2017 11:42 pm
by Johnny
Job done, 2 nuts welded on the back. all primered up and i can weld the pannel on next time i'm in the garage.