Hi, Is it possible to replace the front window draught excluders on my 4 door ser11 S/Screen with everything in situ. Just received replacements from ESM & hope that i can slide them in with the window being wound up & down as i work. Have had the frame out in the past to repl door handle -- 1 pig of a job. Or am I dreaming????
Regards,
Bill
draught excluders
Forum rules
By using this site, you agree to our rules. Please see: Terms of Use
By using this site, you agree to our rules. Please see: Terms of Use
-
- Minor Friendly
- Posts: 25
- Joined: Tue Dec 22, 2015 10:51 am
- Location: Stonehaven, Kincardineshire, Scotland.
- MMOC Member: No
draught excluders
Last edited by Bill4342 on Sun Apr 30, 2017 5:55 pm, edited 2 times in total.
-
- Minor Legend
- Posts: 1186
- Joined: Mon Apr 23, 2007 2:32 pm
- Location: Dartmoor
- MMOC Member: No
Re: draught excluders
I think you should be fine - I did them on both my early and late 1000s with everything in situ. Never replaced the ones on my SII, but I think it should be pretty much the same.
It will be interesting to hear how you find the new draught excluders - the ones I got from one of the suppliers were hopeless (they weren't 'deep' enough, so ended up sitting too far back in the frame) and I ended up buying u-profile felt ones with a metal frame from Woolies - these have been great.
It will be interesting to hear how you find the new draught excluders - the ones I got from one of the suppliers were hopeless (they weren't 'deep' enough, so ended up sitting too far back in the frame) and I ended up buying u-profile felt ones with a metal frame from Woolies - these have been great.