Page 1 of 1

cold heater

Posted: Mon Mar 06, 2017 8:56 pm
by Bill4342
Hi,
Just fitted round heater to my 54 splitscreen. New mechanical take off valve, hoses & return to btm of rad. Flushed & refilled system. Run engine up to operating temp but heater hose only gets hot as far as bulkhead. Removed hose from btm of rad, connected garden hose & water flowed thro htr & out block drain tap. Cannot access htr hoses in situ. Heater fitted under centre of dash. Help!!

Bill.

Re: cold heater

Posted: Tue Mar 07, 2017 7:01 am
by kennatt
probably air locked, squeeze,the hose by hand to try to pump the air out of the system.

Re: cold heater

Posted: Tue Mar 07, 2017 9:55 am
by liammonty
As above - likely an air lock. I've always found that just taking the car for a run, so the revs increase and decrease over a period of time, gets rid of the air locks. If it's just been sitting idling up to temperature, there isn't enough flow to shift the air.

Re: cold heater

Posted: Tue Mar 07, 2017 4:20 pm
by Bill4342
Sorry folks--jumped the gun -- went for a run today and within a mile hot air belching out- Had to turn switch down!!! Yesterday only fast tickover on driveway obviously not enough pressure in system. Well pleased. Thanks for replies.

Bill. :D :D :D

Re: cold heater

Posted: Tue Mar 07, 2017 7:28 pm
by graham1957
sometimes a run up and down steep hills can shift the air