Morris Minor Owners Club

Hi can anyone tell me how often you need to check the timing and also the mixture on the carburetor. I set mine up about two years ago and wondered if I should check it when I service it. Thanks.

If it is running well there is no point in doing anything.
The plugs should be biscuit brown and if they are the mixture is correct.
To check the mixture is correct - lift the carb piston pin and if the engine speeds up slightly and then goes back down again the mixture is correct.
If the engine is pulling well and not pinking then the timing is correct.
Phil

Great many thanks will check when I service it thanks for reply.

For the timing: if it was timed correctly, it should not change unless the contact points burn or the gap reduces due to wear on the fibre cam follower. Soo, timing should only need setting at regular CB changes. Checking with a timing light can be reassuring re timing and advance/retard operation and only takes a few minutes. Proper cam lubrication is more important - to prevent any wear. Electronic ignition with contactless triggers (Hall effect transistors) should never need checking for static timing - just like modern cars.

Culprits for mixture changes are usually due to other components needing service - like a blocked air cleaner or an air leak into the system (I won't say a vacuum leak, as it never happens - it is always an air leak into the vacuum side!)

RAB