Page 1 of 1
bump stop
Posted: Sun Jun 19, 2016 6:50 pm
by dalebrignall
i hit a rough bit of road today and lost one of the front bump stops will i do a lot of damage driving the car with out one , i cant imagine it will hurt for 3 weeks till i can get a new one fitted .
Re: bump stop
Posted: Sun Jun 19, 2016 6:58 pm
by samuria
you just lost one on a bad bit of road!!! if you hit a pot hole on that side it could do damage as it has
nothing to stop it hitting the inner wing etc

Re: bump stop
Posted: Sun Jun 19, 2016 7:21 pm
by Big Jim
Front or back ?
Mine had no front ones fitted when I bought it. I went to a car show today and looked at a minor that had been professionally been restored at great expense ... no front bump stops fitted and the owner didn't know !
Re: bump stop
Posted: Sun Jun 19, 2016 7:34 pm
by bmcecosse
It doesn't take 3 weeks to fit a bump stop - 3 minutes more like! Pop one on right away. Are the dampers well filled with SAE 40 oil??
Re: bump stop
Posted: Sun Jun 19, 2016 7:53 pm
by samuria
big jim... it says front bump stop

Re: bump stop
Posted: Sun Jun 19, 2016 8:17 pm
by dalebrignall
i have not had a propper look at what the nuts are like holding it on are like i suspect they are shot if they are i dont want the grief of fitting it .
Re: bump stop
Posted: Sun Jun 19, 2016 8:19 pm
by Big Jim
samuria wrote:big jim... it says front bump stop

So it does !

Re: bump stop
Posted: Mon Jun 20, 2016 9:46 am
by bmcecosse
It's just two wee nuts and bolts - nothing too it.
Re: bump stop
Posted: Mon Jun 20, 2016 9:56 am
by simmitc
Unless they're rusted solid and need a grinder, or the mounting point has corroded and needs welding, or the damage has already been done by an impact and the inner wing area is distorted, or...
However, agreed that "normally" it's a quick and simple job.
When fitting, remember that they are handed, and should be stamped LH and RH on the mounting plate.
Re: bump stop
Posted: Mon Jun 20, 2016 2:12 pm
by bmcecosse
It's a great pity that no-one has come up with an Aeon type progressive bump stop for the front (and indeed back) of the Minor. Would probably need some form of 'landing plate' fitted on top of the kingpin - but would be a worthwhile improvement. There used to be bump stops of that type for the Mini (from Comps Dept) but haven't seen them for a while.
Re: bump stop
Posted: Tue Jun 21, 2016 6:09 pm
by dalebrignall
i won the battle put some plus gas on the nuts and they just undid not bad after 54 years new one on order .

Re: bump stop
Posted: Tue Jun 21, 2016 7:08 pm
by bmcecosse
I would have fitted two - one each side, obviously...
Re: bump stop
Posted: Tue Jun 21, 2016 8:46 pm
by dalebrignall
ive got yorkshire blood in me roy
Re: bump stop
Posted: Tue Jun 21, 2016 9:11 pm
by bmcecosse
The other one is the same age presumably. It will fall off tomorrow.... Have you beefed up the dampers with the SAE40 oil ??? Is the car running low to be hitting the bump stop like that??