Page 1 of 1
Is it good ?
Posted: Tue Jan 26, 2016 4:44 pm
by Sandun
Hi Can u tell me this Igniation coil Good for Morris that use Dynamo.[frame]
[/frame]
Re: Is it good ?
Posted: Tue Jan 26, 2016 5:18 pm
by bmcecosse
It appears to show '12v' on the side - so it should be ok - but that also looks like a 'ballast' resistor.... so in that case it would not be ok - unless you are intended to use the ballast in series with the coil all the time. Can you measure the resistance (ohms) across the terminals?
Re: Is it good ?
Posted: Wed Jan 27, 2016 7:16 am
by Sandun
Seem to be The old lucas coil out big HT bz of that the normal cheep condensers burn out soon - i Looked for buy a coil so i cant found coil without Ressister part - think the resistence 3.2 with ressiter part.
Re: Is it good ?
Posted: Wed Jan 27, 2016 12:09 pm
by bmcecosse
WITH the resistor connected in series - if it is 3,2 ohms then it will be finee