Page 1 of 1
Bits Needed
Posted: Fri Nov 13, 2015 8:35 pm
by Higgy
Could someone please point(pun not intended) me in the right direction for a set of
points and a condenser for my 1952 Morris Series 2.
Thanks
Shane
Re: Bits Needed
Posted: Fri Nov 13, 2015 9:02 pm
by Trickydicky
Distributor Doctor for the most reliable parts for ignition.
http://www.distributordoctor.com
Re: Bits Needed
Posted: Fri Nov 13, 2015 9:45 pm
by bmcecosse
And get a new rotor arm at the same time.... And test the vacuum advance - if it has failed (more than likely unless replaced in the last 20 years) get a new one too!
Re: Bits Needed
Posted: Fri Nov 13, 2015 10:11 pm
by Higgy
Thanks for the help and advice
Shane
Re: Bits Needed
Posted: Sun Nov 15, 2015 4:45 pm
by mike.perry
Are you sure it is a 1952 Series II? As far as I am aware all the 1952 Series IIs were exported, 1952 cars in this country were Series MMs
Re: Bits Needed
Posted: Mon Nov 16, 2015 9:39 am
by Higgy
Slip of the keyboard it's a 1953
Re: Bits Needed
Posted: Mon Nov 16, 2015 2:32 pm
by mike.perry
Your distributor should be a DM2 although later M1000 25D distributors will fit.