Page 1 of 1
Door Hinge Screws
Posted: Mon Aug 03, 2015 3:04 pm
by 27woodstock
I have been checking all areas for rust etc on my 1963 Traveller. On removing the left hand door I found one of the main/upper hinge screws has been sheared of flush with the hinge. When removing the other screws I noted that they were contaminated with rust but I was able to remove them without to much trouble. One of the screws in the bracket which holds the door snubber was also sheared off. My examination (tapping/pressing) of the door pillar does not indicate any weakness in the pillar. My question is - is there a simple way of gaining access to the plates which hold the hinge screws. These appear to be held loosely on a bracket within the section. Equally I would like to check on the level of rust whilst the doors are off.
Re: Door Hinge Screws
Posted: Mon Aug 03, 2015 3:05 pm
by bmcecosse
Fraid not!
Re: Door Hinge Screws
Posted: Mon Aug 03, 2015 7:01 pm
by jagnut66
Hi,
I had a similar problem a few years ago (on both sides! 
) when I replaced my doors. I overcame it with a long thin bladed screwdriver and allot of patience, which was wearing thin by the time I got the door hinges screwed back in place (it will hold with two screws on the bottom hinge and doesn't seem to move).
When I had work done on the drivers side A post some time later they very handily got the remnants of the old screw out and welded the retaining plate back in place for me. So now I just have the passenger side to contend with again, at some point in the future...................
Best wishes,
Mike.
Re: Door Hinge Screws
Posted: Tue Aug 04, 2015 11:00 pm
by Mark Wilson
If you unbolt the wing it isn't too difficult to cut away part of the cover welded to the back of the pillar and gain access to the fixing plates. Don't cut the whole cover as it provides important stiffening to the pillar. A welder would charge peanuts to patch it back, and it is not visible once the wing is back on. You can also get a good look at the pillar and inner wing while you are at it.
Wouldn't be happy with the plates being welded back in, they need to slide around in their retainers to allow door adjustment.
Mark
Re: Door Hinge Screws
Posted: Tue Aug 11, 2015 7:25 pm
by 27woodstock
Thank you for that Mark. I think I will have ago at cutting some small panels and have a look. The car needs some welding which I have yet to arrange.
Pete
Re: Door Hinge Screws
Posted: Thu Feb 06, 2020 8:22 am
by Sleeper
Mark
" Wouldn't be happy with the plates being welded back in, they need to slide around in their retainers to allow door adjustment. "
Thank you, was going to ask if drilling/tapping a small screw to hold them in place would be a good idea , looks like no , will get some headless bolts to hold them in place while working on the doors/hinges.
Thanks
John ;-)