Morris Minor Owners Club

The lid to the float chamber on my carb has developed a crack and leaks fuel... not a good thing. Trying to track down a replacement. Can anyone point to a definitive source for these?

You can get them straight from SU here: http://sucarb.co.uk/float-chambers-spar ... blies.html .

I've been to them, they don't have them, obsolete...

try burlen carbs on the internet
here is the link
https://burlen.co.uk/

It's the same place!

Just try one of the many Minor traders who have second hand bits. People on here tend to only use or recommend the major suppliers like ESM, Bull Motif and Charles Ware, but forget all the other smaller traders who are likely to have all these second hand bits and bobs. Take a look in the club mag at the adverts to find someone. If you're really stuck, I've a couple of complete carbs, but would rather sell them as complete units.

was probably posted at the same time lol

aupickup wrote:was probably posted at the same time lol

What size carb is it?

Hi Ian. Measure the diameter of the lid and see it you can find a part of the same size on the websites suggested. As it's centre fixing you can swivel the lid round to accommodate the different inlet pipe angle. Be careful over tightening will cause it to crack! If you can't match a top replace the carb with a second hand one they are not that dear. Good luck

As a repair, you could always groove the crack out and fill it with JB Weld, which is a steel loaded epoxy.

I know its glue and is a little bit of a bodge but it really is damned good stuff, once it goes off it gets a really good hold.

It would probably last forever like it, but would certainly do while you fnd one. The auction site is the cheapest place to get it.

Looks like it maybe from old 1 1/2's with brass linkages underneath, if so perhaps not too easy to find spares.

Thanks for the responses folks. Fingers crossed...

Again, what size is the carb!?

Answer the man cos he might say he has got one indoors you can have for postage

Regarding using JB weld to patch the crack, I've found that modern fuel w/ethanol in it will slowly soften up the JB weld.

It will crack again as soon as you tighten the screw....

Hi have you tried Southern Carbs in Sussex they have a web site and recon carbs so may be able to help.

Here you are:-

http://www.ebay.co.uk/itm/SU-H-SERIES-C ... 4d33972cf2

Les
Some 1 1/2" carbs have the small diameter float chamber and some have the large diameter float chamber and is dependent upon application.
I have had both sizes fitted on 1 1/2" carbs fitted to my Minor in the past.
To overcome fuel surge/fuel starvation you can buy float chamber extensions to increase the capacity of the float chamber. Useful if you have large jets and small float chambers.
Phil

It looks like 1 1/8" or 1 1/4" - but since the OP declines to tell us...I can't help!

Sorry, folks, been neglecting this as busy elsewhere. Here are pics of the carb in situ:




Can someone definitively identify the type? I've sent the pics to Burlen to see if they can help.