Page 1 of 1
Exchange dust seal upper trunnion
Posted: Fri May 15, 2015 6:31 pm
by Theo_NL
Hi,
I must replace the upper dust seal as shown in the picture below. Do I have to completely disassemble the whole (top and bottom) or it is possible to disassemble the upper part only?
Theo
[frame]
[/frame]
Re: Exchange dust seal upper trunnion
Posted: Fri May 15, 2015 6:55 pm
by bmcecosse
It comes off very easily.
Re: Exchange dust seal upper trunnion
Posted: Fri May 15, 2015 7:18 pm
by les
I can't believe I'm saying this but with such a insignificant, although necessary part, you could cut the old one off and split the new one ( neatly) with a razor blade, wrap it around the trunnion and superglue it back together but it takes care.
Re: Exchange dust seal upper trunnion
Posted: Mon May 18, 2015 7:49 am
by Theo_NL
Thanks.
I took the challenge and took it apart completely, cleaned everything, new grease, and also replaced the bottom one.
Re: Exchange dust seal upper trunnion
Posted: Mon May 18, 2015 9:17 am
by les
Great, you did it properly!
